Impulsive loading on reinforced concrete slabs.

A number of reinforced concrete slabs have been exposed to blast and impact loading in order to
access modes of slab behaviour under these extreme dynamic loadings.
Two sizes of specimens were used; small scale slabs modelled the large slabs at 1: 2.5 scale.
Impact loads were produced by a free falling hammer impacting coaxially onto a cylindrical bar
of steel placed at rest in the centre of the slab. The steel bar was instrumented with electrical
strain gauges which recorded the stress pulses produced by the impact.
Blast loads were produced using explosive charges made of Plastic Explosive PE4. In most cases
the charge used was hemispherical in shape and was placed centrally above the slab at close range
standoffs, i.e. up to 10 times the radius of the charge.
Additional blast tests were conducted in order to monitor the transient and spatial pressure
distribution across the slab by using the pressure gauges placed in replica steel slab.
Transient deflections of the slabs under both types of load were obtained using long stroke
displacement transducers, whilst transient strains in the steel reinforcement of the slabs were
obtained using electrical resistance strain gauges bonded to the steel bars at mid span point.
A rotating prism high speed camera was used to film the damage on some of the small scale
specimens at rates of up to 10,000 pictures per second.
The Hopkinson pressure bar tests were used to obtain the dynamic characteristics of the concretes
used at high rates of loading. Differeent concrete mixes were used for the 1:1 and 1:2.5 scale
slabs.
An analytical function of the spatial and transient blast pressure distribution based on the
detonation pressure of PE4 was established. This is in close agreement to experimentally
measured results.
The nature of the local and overall failure are discussed, and the time sequence of the slab failure
is established for the case of explosive loading.
The crack pattern that occurs soon after the explosion in area of local failure has been established
from the high speed films whilst the overall deflected shape was obtained from the displacement
vs time records.
After test scab sizes and slab perforations were used to establish a relation between the slab
thickness, amount of explosive and the slab damage in respect to scabbing and perforation.
The displacement records and the shape of after test damage provided the basis for comments on
"gravity neglected - the ultimate strength" modelling law that was employed in this research.