White Rose University Consortium logo
University of Leeds logo University of Sheffield logo York University logo

Fundamental modelling of friction during the hot rolling of steel.

Jupp, Simon Peter (2006) Fundamental modelling of friction during the hot rolling of steel. PhD thesis, University of Sheffield.

[img] Text (421158.pdf)
421158.pdf

Download (23Mb)

Abstract

Friction is one of the most significant physical phenomena influencing metal forming, yet in comparison with metallurgy, heat transfer and mechanics it remains the least understood. The goal of this project was to develop, on as fundamental a level as possible, a friction model based upon the physics of the process to be applied to the hot rolling of steel. A fundamental friction model was developed based upon the simplified approach to the adhesion theory by Straffelini (Wear, 249, 79-85, 2001), which is an extension of Bowden and Tabor's original adhesion theory. In this work, the simplified approach's dependence on the thermodynamic work of adhesion was exploited to apply it over a wide range of temperatures. The thermodynamic work of adhesion describes the work required to form a new surface and is a function of the surface energy of the contacting materials was estimated using two approaches: Rabinowicz's and the geometric mean rule. Since high temperature surface energy data is not generally available the relative change in Young's modulus with temperature was used to estimate a material's surface energy at a desired temperature. Reciprocating friction experiments, which provided a controlled environment in which to investigate friction, were conducted to verify the application of this theory to high temperature conditions and metal-oxide contacting materials. The fundamental model describing friction was applied to the hot rolling of steel via a friction algorithm using the commercial finite element (FE) code MARC. Simply described the friction algorithm calculated a friction coefficient using material properties, defined by the user, and contact temperatures, taken from the rolling model. This resulted in the friction coefficient predicted throughout the roll bite, compared to an average friction coefficient typically employed in rolling models. The combined friction algorithm-rolling model was validated against laboratory rolling experiments. One of the assumptions of the finite element rolling model is the presence of a thin, continuous and adherent scale layer. To achieve this in the laboratory a two pass rolling schedule was employed; the first pass to remove the furnace scale and the second pass to input the desired deformation. The success of the friction algorithm was determined by comparing the experimental torques and loads to the predictions of the finite element model. The FE model with the friction algorithm predicted the friction coefficient to vary in the roll gap between approximately 0.25 and 0.35 and was able to predict the measured rolling torque with an average error of 15%, which was considered acceptable and the accuracy was increased after the bearing torque was considered. The error in the load predictions compared to the measured loads was 13.5% on average, which was also acceptable.

Item Type: Thesis (PhD)
Academic Units: The University of Sheffield > Faculty of Engineering (Sheffield) > Materials Science and Engineering (Sheffield)
Identification Number/EthosID: uk.bl.ethos.421158
Depositing User: EThOS Import Sheffield
Date Deposited: 22 Nov 2016 11:43
Last Modified: 22 Nov 2016 11:43
URI: http://etheses.whiterose.ac.uk/id/eprint/14637

You do not need to contact us to get a copy of this thesis. Please use the 'Download' link(s) above to get a copy.
You can contact us about this thesis. If you need to make a general enquiry, please see the Contact us page.

Actions (repository staff only: login required)